Abstract
A high sensitive refractive index sensor based on the cladding etched photonic crystal fiber (PCF) Mach-Zehnder interferometer (MZI) is proposed, which is spliced a section of photonic crystal fiber between two single modes fibers (SMFs).The interference fringe of the MZI shifts with the variation of the ambient refractive index (RI). It is found that the RI sensitivity slightly decrease with an increase in the interference length. The sensitivities of MZI with 35 mm PCF, 40 mm PCF, and 45 mm PCF are 106.19 nm/RIU, 93.33 nm/RIU, and 73.64 nm/RIU, respectively, in the range of 1.333 to 1.381. After etched, the RI sensitivity of the MZI could be improved obviously. The RI sensitivities of the MZI with 35 mm PCF are up to 211.53 nm/RIU and 359.37 nm/RIU when the cladding diameter decreases to 112 μm and 91 μm, respectively. Moreover, the sensor is insensitive to temperature, and the measured sensitivity is only 9.21 pm/°C with the range from 20°C to 500°C. In addition, the sensor has advantage of simple fabrication, low cost, and high RI sensitivity.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
X. Y. Sun, X. R. Dong, Y. W. Hu, H. T. Li, D. K. Chu, J. Y. Zhou, et al., “A robust high refractive index sensitivity fiber Mach-Zehnder interferometer fabricated by femtosecond laser machining and chemical etching,” Sensors & Actuators A: Physical, 2015, 230: 111–116.
J. H. Wo, G. H. Wang, Y. Cui, Q. Sun, R. B. Liang, P. Shum, et al., “Refractive index sensor using microfiber-based Mach-Zehnder interferometer,” Optics Letters, 2012, 37(1): 67–69.
Q. Wang, L. X. Kong, Y. L. Dang, F. Xia, Y. W. Zhang, Y. Zhao, et al., “High sensitivity refractive index sensor based on splicing points tapered SMF-PCF-SMF structure Mach-Zehnder mode interferometer,” Sensors & Actuators B: Chemical, 2016, 225: 213–220.
J. N. Wang and J. L. Tang, “Photonic crystal fiber Mach-Zehnder interferometer for refractive index sensing,” Sensors, 2012, 12(3): 2983–2995.
B. Y. Li, L. Jiang, S. M. Wang, H. L. Tsai, and H. Xiao, “Femtosecond laser fabrication of long period fiber gratings and applications in refractive index sensing,” Optics & Laser Technology, 2011, 43(8): 1420–1423.
F. Zou, Y. Q. Liu, C. L. Deng, Y. H. Dong, S. Zhu, and T. Y. Wang, “Refractive index sensitivity of nano-film coated long-period fiber gratings,” Optics Express, 2015, 23(2): 1114–1124.
W. Liang, Y. Huang, Y. Xu, R. K. Lee, and A. Yariv, “Highly sensitive fiber Bragg grating refractive index sensors,” Applied Physics Letters, 2005, 86(15): 151122–1–151122–3.
T. Wei, Y. K. Han, Y. J. Li, H. L. Tsai, and H. Xiao, “Temperature-insensitive miniaturized fiber inline Fabry-Perot interferometer for highly sensitive refractive index measurement,” Optics Express, 2008, 16(8): 5764–5769.
X. Y. Sun, D. K. Chu, X. R. Dong, C. Zhou, H. T. Li, L. Zhi, et al., “Highly sensitive refractive index fiber inline Mach-Zehnder interferometer fabricated by femtosecond laser micromachining and chemical etching,” Optics & Laser Technology, 2016, 77: 11–15.
P. Lu, L. Q. Men, K. Sooley, and Q. Chen, “Tapered fiber Mach-Zehnder interferometer for simultaneous measurement of refractive index and temperature,” Applied Physics Letters, 2009, 94(13): 131110–1–131110–3.
X. R. Dong, Z. Xie, Y. X. Song, K. Yin, D. K. Chu, and J. A. Duan, “High temperature-sensitivity sensor based on long period fiber grating inscribed with femtosecond laser transversal-scanning method,” Chinese Optics Letters, 2017, 15(9): 090602–1–090602–5.
X. R. Dong, Z. Xie, C. Zhou, K. Yin, Z. Luo, and J. A. Duan, “Temperature sensitivity enhancement of platinum-nanoparticle-coated long period fiber gratings fabricated by femtosecond laser,” Applied Optics, 2017, 56(23): 6549–6553.
T. A. Birks, J. C. Knight, and P. S. J. Russell, “Endlessly single-mode photonic crystal fiber,” Optics Letters, 1997, 22(13): 961–963.
Y. Zhao, X. G. Li, L. Cai, and Y. Yang, “Refractive index sensing based on photonic crystal fiber interferometer structure with up-tapered joints,” Sensors & Actuators B: Chemical, 2015, 221: 406–410.
D. Wu, Y. Zhao, and J. Li, “PCF taper-based Mach-Zehnder interferometer for refractive index sensing in a PDMS detection cell,” Sensors & Actuators B: Chemical, 2015, 213: 1–4.
Y. Zhao, F. Xia, H. F. Hu, and M. Q. Chen, “A novel photonic crystal fiber Mach-Zehnder interferometer for enhancing refractive index measurement sensitivity,” Optics Communications, 2017, 402: 368–374.
D. Pawar and S. N. Kale, “Birefringence manipulation in tapered polarization-maintaining photonic crystal fiber Mach-Zehnder interferometer for refractive index sensing,” Sensors & Actuators A: Physical, 2016, 252: 180–184.
Y. C. Tan, Z. Q. Tou, V. Mamidala, K. K. Chow, and C. C. Chan, “Continuous refractive index sensing based on carbon-nanotube-deposited photonic crystal fibers,” Sensors & Actuators B: Chemical, 2014, 202: 1097–1102.
L. Melo, G. Burton, P. Kubik, and P. Wild, “Refractive index sensor based on inline Mach-Zehnder interferometer coated with hafnium oxide by atomic layer deposition,” Sensors and Actuators B: Chemical, 2016, 236: 537–545.
T. Zhu, F. F. Xiao, L. C. Xu, M. Liu, M. Deng, and K. S. Chiang, “Pressure-assisted low-loss fusion splicing between photonic crystal fiber and single-mode fiber,” Optics Express, 2012, 20(22): 24465–24471.
D. K. Sharma and A. Sharma. “Mode field expansion in index-guiding microstructured optical fibers,” SPIE, 2013, 8794: 87942A-1–87942A-6.
L. C. Li, L. Xia, Z. H. Xie, and D. M. Liu, “All-fiber Mach-Zehnder interferometers for sensing applications,” Optics Express, 2012, 20(10): 11109–11120.
Y. Zhao, M. Q. Chen, F. Xia, and H. F. Hu, “Spectrum online-tunable Mach-Zehnder interferometer based on step-like tapers and its refractive index sensing characteristics,” Optics Communications, 2017, 403: 143–149.
L. Cai, Y. Zhao, and X. G. Li, “A fiber ring cavity laser sensor for refractive index and temperature measurement with core-offset modal interferometer as tunable filter,” Sensors & Actuators B: Chemical, 2017, 242: 673–678.
R. Xiong, H. Y. Meng, Q. Q. Yao, B. Huang, Y. M. Liu, H. C. Xue, et al., “Simultaneous measurement of refractive index and temperature based on modal interference,” IEEE Sensors Journal, 2014, 14(8): 2524–2528.
L. Q. Wang, L. Yang, C. Zhang, C. Y. Miao, J. F. Zhao, and W. Xu, “High sensitivity and low loss open-cavity Mach-Zehnder interferometer based on multimode interference coupling for refractive index measurement,” Optics and Laser Technology, 2019, 109: 193–198.
Acknowledgement
This research work is supported by the National Natural Science Foundation of China (NSFC) (Grant Nos. 51475482, 51875584, 51875585, and 51475481), the National Key R&D Program of China (Grant Nos. 2017YFB1104800 and 2018YFB1107803), and the Fundamental Research Funds for the Central Universities of Central South University.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (https://doi.org/creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.
About this article
Cite this article
Du, H., Sun, X., Hu, Y. et al. High Sensitive Refractive Index Sensor Based on Cladding Etched Photonic Crystal Fiber Mach-Zehnder Interferometer. Photonic Sens 9, 126–134 (2019). https://doi.org/10.1007/s13320-019-0532-2
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13320-019-0532-2