Abstract
Selected mine tailings in northern-central Chile were geochemically and mineralogically studied for their economic potential and environmental impact. High bulk Co content up to 1500 ppm and Cu content up to 9100 ppm are caused by Co-bearing pyrite, chalcopyrite, and their secondary products such as malachite and Co-Cu-carrying Fe-hydroxides. Due to high amount of sulfide minerals acid mine drainage (AMD) is forming in the oxidized upper part of the tailing, which makes a retreatment in dispensable to reduce the environmental impact.
You have full access to this open access chapter, Download conference paper PDF
Similar content being viewed by others
Keywords
1 Introduction
Since Chile is the largest Cu producing country with the biggest reserves, Chilean mining industry generates huge quantities of mining residues, amongst others in the form of tailings dumps. The fact that some of them were generated many decades ago, where process technology was inadequate in comparison to today, makes some of them economically interesting. Due to advanced weathering, the tailings, which are potentially acid producing, bear an environmental hazard. Therefore, our aim is to investigate the geochemistry and mineralogy of the tailings in order to determine their economic potential and environmental impact.
The studied mine tailings dump is located in the region of Coquimbo, where an arid Mediterranean climate with mean annual temperature of 14.6 °C, precipitation of 132 mm, and evaporation of about 1702 mm prevails (Mora et al. 2007). Geologically, the region is characterized by Early Cretaceous Chilean Manto-type (volcanic-hosted stratiform) Cu deposits (Kojima et al. 2003) that are the most probable source of the studied tailings.
2 Methods and Approaches
Eight drill cores with lengths of seven meters were taken from the tailings dump (Fig. 1). Bulk geochemistry of homogenized material for each meter was investigated using a standard WDXRF. Mineralogy was studied on representative grain concentrates obtained by gravity separation. Abundance of the minerals was analyzed by MLA and composition of the minerals was examined by EPMA.
3 Results and Discussion
The tailings material consists of alternating layers of sand, silt and clay. According to geochemical pattern, the tailings dump can be subdivided into three groups, as shown in Fig. 1. Heap I and II are enriched in Fe and Co (Fig. 2). Special feature of heap I is a depletion in S and Ca but a high percentage of loss on ignition (LOI). It may point to a weathered part of the tailings dump, where oxidation of pyrite results in dissolution of calcite and accumulation of water bearing secondary clay minerals. Heap III contains high amounts of host rock and therefore elevated contents of Si, Al, Mg, Na, K and P can be seen. It is strongly enriched in Cu but only at the near surface level (Fig. 2).
Primary gangue minerals in heap I and II are epidote, quartz, andradite, and albite pointing towards skarn mineralization. The only difference between the two heaps is the absence of calcite in the heap I confirming the bulk geochemistry. The most common primary ore mineral in both heaps is pyrite, which occurs as liberated grains. Three types of pyrite were identified. The first type is pure pyrite. The second type has an As-rich rim with up to 8.7 wt% As (Fig. 3a) and is predominantly present in the heap II resulting in an elevated bulk content of As (Fig. 1). The third type contains a significant amount of Co. Hereby, the Co concentration increases from rim to core and can reach up to 3.8 wt%. Additional trace elements are e.g. up to 0.5 wt% Ni, 0.1 wt% Cu, and 0.2 wt% Cd. Remaining primary ore minerals are magnetite, hematite and trace amounts of chalcopyrite. They also occur as well liberated grains and are occasionally inter grown with each other. These minerals do not contain significant amounts of trace elements.
Secondary phases are gypsum and Fe-hydroxides as weathering products of calcite and pyrite (Fig. 3b) and preferentially occur in heap I. Such in-situ precipitation of Fe-hydroxides can only take place at near neutral pH proving an initial occurrence of calcite as a buffering agent in the strongly weathered heap I. The Fe-hydroxides contain high concentrations of Co (up to 0.9 wt%), Cu (up to 2.5 wt%) and Ca (up to 4.3 wt%), pointing to a dissolution of pyrite, chalcopyrite and calcite and fixation of released metals in Fe-hydroxides. The analyzed saturated soil extraction had a pH of 2. Its Co and Cu contents were 103 and 136 mg/l respectively, whereas Hg, Cd, As, Zn and Pb contents remained under 2.4 mg/l. Especially, the Co and Cu values exceed the international guidelines (IFC 2007 and Gusek and Figueroa 2009) by more than a factor of 100.In fact, the potential for AMD is high in the oxidized parts of the heaps.
The heap III predominantly consists of gangue minerals. The most common mineral is quartz followed by albite, anorthite, micas, K-feldspar, amphibole, epidote, pyroxene, chloride, and calcite. A Minor amount of Fe-oxides and chalcopyrite exists, either as liberated grains or finely intergrown with gangue minerals. Chalcopyrite is strongly replaced by Fe-hydroxides and Cu-carbonates along grain boundaries and micro fractures.
4 Conclusion
Bulk geochemistry provides a good prediction of the mineralogy. Elevated amounts of Fe, Co, and S in the heaps I and II correspond to Co-bearing pyrite-rich waste material. In contrast, heap III consists of host rock forming elements resulted by non-sulfidic gangue mineral waste. From an economic point of view, Co is the only valuable metal in the heap I and II. For the extraction magnetic separation should be performed to eliminate high amounts of magnetite. Heap I contains extensive amounts of Co- and Cu-rich Fe-hydroxides that usually coat pyrite grains. Therefore, leaching can be directly applied to extract acid soluble Co and Cu and also to liberate pyrite grains. Otherwise, pyrite cannot be floated. Afterwards, pyrite from both sulfidic heaps can be floated and Co can be extracted by bioleaching. In case of heap III, only the uppermost first meter, which is Cu-rich, should be treated. Cu occurs preferentially as acid soluble mineral such as malachite and Cu-rich Fe-hydroxides. However, calcite would have to be removed by gravity separation to reduce the consumption of sulfuric acid. Otherwise, itis economically not feasible. From an environmental point of view, heap III poses no environmental risk because it does not host AMD potential. Oxidation of minor chalcopyrite will be buffered by the carbonate content. In turn, the sulfidic tailings should be immediately treated, because the potential of AMD generation due to heavy rains is high. The hazardous potential of the impoundment should not be underestimated because of agricultural activities in the vicinity.
References
Gusek JJ, Figueroa LA (2009) Mitigation of metal mining influenced water (Management Technologies for Metal Mining Influenced Water, vol 2), Soc Min Metall Explor. Littleton, Colorado
IFC (2007) Environmental, health and safety guidelines for mining. International Finance Corporation, World Bank Group, DC, 33 p
Kojima S, Astudillo J, Rojo J, Tristá D, Hayashi K (2003) Ore mineralogy, fluid inclusion, and stable isotopic characteristics of stratiform copper deposits in the coastal Cordillera of Northern Chile. Miner Deposita 38:208–216
Mora F, Tapia F, Scapim SA, Martins EN (2007) Vegetative growth and early production of six olive cultivars, in Southern Atacama Desert, Chile. J Cent Eur Agric 8(3):269–276
Acknowledgements
This investigation is supported by DERA the German Mineral Resources Agency of BGR.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Open Access This chapter is licensed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license and indicate if changes were made.
The images or other third party material in this chapter are included in the chapter's Creative Commons license, unless indicated otherwise in a credit line to the material. If material is not included in the chapter's Creative Commons license and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder.
Copyright information
© 2019 The Author(s)
About this paper
Cite this paper
Berkh, K., Rammlmair, D., Drobe, M., Meima, J. (2019). Case Study: Geochemistry and Mineralogy of Copper Mine Tailings in Northern Central-Chile. In: Glagolev, S. (eds) 14th International Congress for Applied Mineralogy (ICAM2019). ICAM 2019. Springer Proceedings in Earth and Environmental Sciences. Springer, Cham. https://doi.org/10.1007/978-3-030-22974-0_9
Download citation
DOI: https://doi.org/10.1007/978-3-030-22974-0_9
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-030-22973-3
Online ISBN: 978-3-030-22974-0
eBook Packages: Earth and Environmental ScienceEarth and Environmental Science (R0)