Abstract
Driven by government policy and incentives, solar power production has soared in the past decade and become a mainstay during the worldwide clean-power transition process. Among the various next-generation photovoltaic technologies, perovskite solar cells (PSCs) are the most important emerging area of research due to their outstanding power conversion efficiency and affordable scale-up operation. We adopted the nonlocal strain gradient theory and the first-order shear deformation plate theory to investigate the size-dependent free vibration behavior of PSCs. The size-dependency in the nanostructure of the PSCs was captured by coupling the nonlocal and strain gradient parameters. In accordance with the Hamilton principle, the governing equations set was derived. Subsequently, the Galerkin procedure was applied to address the dynamic characteristics analysis of PSCs with simply supported and clamped edges. Compared with the size-insensitive traditional continuum plate model, the current multiscale framework revealed a size effect on the free vibration of the PSC. Moreover, some parametric experiments were conducted to explore the impacts of scale length parameter, nonlocal parameter, and boundary conditions on the natural frequency of the PSC.
You have full access to this open access chapter, Download conference paper PDF
Keywords
1 Introduction
The perovskite solar cell (PSC) has garned tremendous attention from the scientific community over the past few years due to outstanding optical and electronic properties [1]. This new-generation photovoltaic device rose to prominence in 2012 with an energy conversion efficiency of 9.7% and then rapidly achieved a new certified record with 25.7% in 2022 [2]. Although PSCs have proven their competitive power conversion efficiencies and the prospect of further improved performance, their structural response during their operational lifetime still lacks investigation [3]. The study of the free vibration of PSC lays a solid foundation for optimizing the structure, because it is a crucial part of analyzing the dynamic response to various loading scenarios.
For mainstream solar power generation, technologies cannot be deployed in the field without accurately estimating their structural response. Despite the significance in real-life applications, there are few studies on the size-dependent dynamic characteristics of PSCs among the broad spectrum of available scientific reports that emphasize the interest and importance of this topic. Thus, we attempted to fill this gap by using nonlocal strain gradient theory (NSGT) to reveal the size effect of the free vibration behavior of the PSC with both simply supported and clamped boundary conditions.
2 Methods
2.1 Formulations
Grounded on NSGT [4], the internal energy density potential incorporating nonlocality and higher-order strain gradient tensor were formulated as:
where \(\varepsilon_{ij}\) and \(\varepsilon_{ij}^{\prime }\) are the strain tensors at the arbitrary point x and its neighboring point \(x^{\prime}\) in \(V\), respectively; \(C_{ijkl}\) denotes the elastic coefficients of the classical elasticity; \(\alpha_{0}\) and \(\alpha_{1}\) indicate the nonlocal attenuation function and the additional kernel function, correspondingly, which are related to the nonlocal parameters \(e_{0} a\) and \(e_{1} a\), and the distance between the considered points \({\text{x}}\) and \(x^{\prime}\) in V; \(e_{0}\) and \(e_{1}\) refer to the material constants; \(a\) is the internal characteristic length, \(l\) is a material length scale parameter which describes the higher-order strain gradient field.
The constitutive equations in NSGT herein can be described as:
where \(\nabla\) represents the Laplacian operator. The total stress tensor predicted by the NSGT can be then expressed as:
Based on the assumption that the same nonlocal attenuation functions and parameters are taken, namely, \(e_{1} a = e_{0} a\), then a general constitutive relation yields:
Integrating by parts, then collecting the coefficients of \(\delta u_{0}\), \(\delta v_{0}\), \(\delta w_{0}\), \(\delta \theta_{x}\), and \(\delta \theta_{y}\) to zero, the governing equations of the size-dependent PSC can be obtained. Then, corresponding to the investigated boundary conditions, the generalized displacements \(\left[ {u_{0} ,v_{0} ,w_{0} ,\theta_{x} ,\theta_{y} } \right]\) can be expanded in double trigonometric series. With the aid of the Galerkin method, the governing equations can be derived in the following form:
By solving the above eigenvalue problem, the natural frequency of the nanostructures \(\omega_{nl}\) can be resolved from the smallest eigenvalue.
3 Numerical Results
In NSGT the size-dependency of the nanostructure is characterized as nonlocal parameters \(e_{0} a\) and material length scale parameters \(l_{0}\). It should be noted that the current NSGT can degenerate into other lower-order continuum models by adjusting the related coefficients. Specifically, a pure NET model, \(l_{0} = 0\) is taken to eliminate the strain gradient term. In terms of the system not including stress nonlocality, \(e_{0} a = 0\). For the classical continuum model, herein the first-order shear deformation plate theory (FSDT), without considering the nonlocality and higher-order strain gradient, \(e_{0} a = l_{0} = 0\).
The PSC is fabricated with a layer stack sequence of FTO/TiO2/Perovskite/Spiro-MeOTAD/Au. The total thickness, length, and width of a PSC are \(h = 1587.5{\text{nm}}\) and \(L_{a} = L_{b} = 0.2{\text{mm}}\), respectively. The related material properties can be found in [5]. The dimensionless parameters are introduced as \(\overline{{e_{0} a}} = \frac{{e_{0} a}}{{L_{a} }}\), \(\overline{{l_{0} }} = \frac{{l_{0} }}{{L_{a} }}\).
The natural frequency of the simply supported and clamped PSCs with various dimensionless nonlocal and material length parameters is shown in Fig. 1. It can be seen that, for both boundary conditions, the increase of the two size effect parameters results in distinct variations in the natural frequency of the PSC. With the attendance of the nonlocal parameter, the natural frequency of the PSC demonstrates a declined trend. However, the material length scale parameter tends to enhance \(\omega_{nl}\) in the considered range. One possible explanation is that the nonlocal parameter addresses the effect of stiffness-softening, whereas the material length scale parameter addresses the effect of stiffness-hardening. In particular, the effects induced by the size-dependent coefficients become more prominent when their values approach the geometric size of the structure. Moreover, under two boundary restraints, as predicted, the clamped PSC possessed greater natural frequency than the supported plate due to the additional constraints.
4 Conclusions
In the present study, the size-dependency on the dynamic characteristics behavior of the PSC wasinvestigated based on NSGT. By introducing the nonlocal parameter and the material length scale parameter, the size-tendency of the nanostructure was captured in a complicated mix of stiffness-softening and stiffness-hardening. It was revealed that both scale parameters play crucial roles in the free vibration of the PSC. Moreover, it should be noted that the size-dependent model showed its characteristics as the scale parameters approached the dimensions of the structure.
References
Nayak PK, Mahesh S, Snaith HJ, Cahen D (2019) Photovoltaic solar cell technologies: analysing the state of the art. Nat Rev Mater 4:269–285. https://doi.org/10.1038/s41578-019-0097-0
Perovskite Solar Cells|Department of Energy n.d. https://www.energy.gov/eere/solar/perovskite-solar-cells. Accessed October 26, 2020
Nair S, Patel SB, Gohel JV (2020) Recent trends in efficiency-stability improvement in perovskite solar cells. Mater Today Energy 17:100449. https://doi.org/10.1016/j.mtener.2020.100449
Lim CW, Zhang G, Reddy JN (2015) A higher-order nonlocal elasticity and strain gradient theory and its applications in wave propagation. J Mech Phys Solids 78:298–313. https://doi.org/10.1016/j.jmps.2015.02.001
Li Q, Tian Y, Wu D, Gao W, Yu Y, Chen X et al (2021) The nonlinear dynamic buckling behaviour of imperfect solar cells subjected to impact load. Thin-Walled Struct 169:108317. https://doi.org/10.1016/J.TWS.2021.108317
Acknowledgements
This research was supported by an Australian Government Research Training Program Scholarship and Australian Research Council projects IH150100006, IH200100010, and DP210101353.
Author information
Authors and Affiliations
Corresponding authors
Editor information
Editors and Affiliations
Rights and permissions
Open Access This chapter is licensed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license and indicate if changes were made.
The images or other third party material in this chapter are included in the chapter's Creative Commons license, unless indicated otherwise in a credit line to the material. If material is not included in the chapter's Creative Commons license and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder.
Copyright information
© 2023 The Author(s)
About this paper
Cite this paper
Li, Q., Wu, D., Gao, W. (2023). Insights into the Size Effect of the Dynamic Characteristics of the Perovskite Solar Cell. In: Duan, W., Zhang, L., Shah, S.P. (eds) Nanotechnology in Construction for Circular Economy. NICOM 2022. Lecture Notes in Civil Engineering, vol 356. Springer, Singapore. https://doi.org/10.1007/978-981-99-3330-3_37
Download citation
DOI: https://doi.org/10.1007/978-981-99-3330-3_37
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-99-3329-7
Online ISBN: 978-981-99-3330-3
eBook Packages: EngineeringEngineering (R0)