Correction: J Wood Sci (2021) 67:23 https://doi.org/10.1186/s10086-021-01954-y
In the calculation of normal and shear stress in each layer using Eqs. 7a–8b, there was an error in inputting the modulus of elasticity for Hinoki and Sugi. Erroneously, values of 12.5 GPa and 8.6 GPa were used, respectively, instead of the correct elastic moduli listed in Table 1. It should be noted that these erroneously input values were actually the partial means, consisting of the correct values found in Table 1.
Originally, the correct values were used for stiffness calculation of imaginary beam A and B.
Therefore, the impact of aforementioned input errors was confined to the calculation of sectional stress. Following the correction of these values, the recalculated results showed a slight overall increase, but it did not affect the conclusions drawn in the paper [1].
As a result of this re-calculation, corrections have been made to Figs. 11, 12, 13 and 14, as well as Tables 5 and 6.
The corrections in the main text are clearly indicated below:
In the Abstract section, the sentence that reads as “The magnitude……the mean shear strength of the cross layer was estimated to be 1.33 MPa.” should read as “The magnitude……the mean shear strength of the cross layer was estimated to be 1.48 MPa.”
In page 15, under the section “Shear modulus in cross layer obtained from strain measurement”, the sentence that reads as “The mean of the rolling shear G90_ex was 79.0 MPa with a coefficient of variation of 19%.” should read as “The mean of the rolling shear G90_ex was 81.3 MPa with a coefficient of variation of 19%.”
In page 17, under the section, “Rolling shear strength of cross layer”, the sentence that reads as “The estimated shear strength of the cross layer was 1.33 MPa.” should read as “The estimated shear strength of the cross layer was 1.48 MPa.”
In page 17, under the section, “Conclusions”, the sentence that reads as “From the regression……the mean shear strength of the cross layer was estimated to be 1.33 MPa.” should read as “From the regression……the mean shear strength of the cross layer was estimated to be 1.48 MPa.”
Reference
Ukyo S, Miyatake A, Shindo K, Hiramatsu Y (2021) Shear strength properties of hybrid (hinoki cypress and Japanese cedar) cross-laminated timbe. J Wood Sci 67:23. https://doi.org/10.1186/s10086-021-01954-y
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
This article is published under an open access license. Please check the 'Copyright Information' section either on this page or in the PDF for details of this license and what re-use is permitted. If your intended use exceeds what is permitted by the license or if you are unable to locate the licence and re-use information, please contact the Rights and Permissions team.
About this article
Cite this article
Ukyo, S., Miyatake, A., Shindo, K. et al. Correction: Shear strength properties of hybrid (hinoki cypress and Japanese cedar) cross-laminated timber. J Wood Sci 70, 11 (2024). https://doi.org/10.1186/s10086-024-02124-6
Published:
DOI: https://doi.org/10.1186/s10086-024-02124-6